1L Corrosion Inhibitor for Heating and Cooling Circuits

Corrosion inhibitor for heating and cooling systems, must be used in case the liquid circulating in the system does not exert a sufficient passivation on the metal parts it is composed of. for example, when the circulating antifreezing product has been too much exploited, inhibitor salts must be restored.

What we like about this Regenerating Antifreeze:

• Technical support instality on using the product for optimum treatment
• Product corrosion inhibitor for heating and cooling circuits
• It is to be used in the case in which the liquid circulating in the system does not exercise a sufficient passivation on the metal parts of which it is composed
• Add 3 - 4 or 5 % of corrosion inhibitor to glycol. Slightly shake the mixture to homogenize it.
• Available in tank 1L
• Technical data sheet available for download here on this page

TECHNICAL DATA:
Composition aqueous solution of a special package of inhibitors and perfectly balanced with special additives for the protection of aluminium, its alloys and of common metals which constitute the heating and refrigeration.

• Appearance: light turbidity
• Colour: straw
• Odor: odorless
• Relative density at 15 °C: 1,350 ± 0,050 g/cm³
• pH at 20 °C: 11,0 ± 0,5
• Vapour pressure at 20 °C: 2700 Pa
• Solubility in water: complete
• Boiling point: 100 °C
• Flash point: not flammable
• Crystallization point: -8 °C
• Stability: 12 months

How to use:

Circulate with MGFTools pump in addition to the glycol, to the maximum flow rate, so that the induced turbulence can homogenize the solution obtained.